Your browser is not supported. | ||
Please browse our site using any of the following options:
| ||
PURE WOOL 8PLY DIAGONAL CUSHION
Level: Easy
What you'll need:
- 50g '4 Seasons' pure wool 8 ply x 6 balls 1st colour (c1-oats), 2 ball 2nd colour (c2-yellow), 2 ball 3rd colour (c3-tangerine), 2 ball 4th colour (c4-beige)
- 4mm knitting needles x 1 pair or size required to give correct tension
- Scissors
- Yarn needle
- Tape measure
- 51cm x 51cm cushion insert
Measurements
Width (approx. finished) 50 cm
Length (approx. finished) 50 cm
Instructions
Tension
19 sts to 10cm in width over garter st, using 4mm needles.
Cushion (make 2 pieces)
Using 4mm needles and C1, cast on 3 sts.
Beg Increasing - 1st row (WS) - Knit.
2nd row - K1, inc knitways in next st, K1 ... 4 sts.
3rd row - K1, inc knitways in next st, knit to end ... 5 sts.
Rep 3rd row until side edge measures 3.5cm, working last row on WS.
** Using C2, rep 3rd row until side edge measures a further 3.5cm, working last row on WS.
Using C1, rep 3rd row until side edge measures a further 3.5cm, working last row on WS. **
Rep from ** to ** twice more.
*** Using C3, rep 3rd row until side edge measures a further 3.5cm, working last row on WS.
Using C1, rep 3rd row until side edge measures a further 3.5cm, working last row on WS. ***
Rep from *** to *** twice more.
Using C4, rep 3rd row until side edge measures a further 3.5cm, working last row on WS ... approx. 49cm in all.
Beg Decreasing -
**** Using C1, 1st row - K1, K2tog, knit to end.
Rep 1st row until next side edge measures a further 3.5cm, working last row on WS.
Using C4, rep 1st row until side edge measures a further 3.5cm, working last row on WS. ****
Rep from **** to **** once more.
***** Using C1, rep 1st row until side edge measures a further 3.5cm, working last row on WS.
Using C2, rep 1st row until side edge measures a further 3.5cm, working last row on WS. *****
Rep from ***** to ***** until 3 sts rem (thus ending with a 3.5cm stripe in C2) ... approx. 49cm in all.
Cast off.
FINISHING
Do not press. Using mattress st, join the 2 pieces together along 3 sides. Place insert inside and close opening.